Pixelhate's corner

[Hoboapple]

Still, the physics are just off a little.

[GuitarMangler]

Upon close inspection to the pinball animation I spotted two things to work on. Both physics related.

One is density, the ball kept bouncing different amounts, unless its changing its consistency then it shouldn't be doing that.

The other is arching, when it bounces it should go in the shape of a rainbow, yours were getting cut off and dropping straight down in the middle.

Keep up the good work!

[Pixelhate]

Thanks for explanation man ! I can see it better know !

[DarkFlame]

Export them at a higher frame delay! They are FAST!

[Pixelhate]

I'm confused !! They where made to run at 20 fps and exported at 5/100 (which is the correct ratio, I guess). I was told to lower the frame delay previously. What would be the appropriate frame delay, in your opinion. And how can you tell it's too fast ? ( I need to learn what and where to look , help me ?..)

[Hoboapple]

20 FPS should be exported at 3.

[EmPeeKay]

1/20= 0.05

Pixal hate is right on the frame delay. It should be 5.

[Pixelhate]

20 FPS should be exported at 3.

could you elaborate ?
To me :
If 20fps = 1 second
1 frame = 1/20 second
if 1 second = 100
then 1/20 sec = 5/100 => export at 5

[DarkFlame]

All I know is everythings too fast.

[GuitarMangler]

I think the frame delay is fine, personally I animate at 4 though.