More halp please.

[Zangdotstyk]

I'll try to fit all of my problems into this one.

I've done some frames in my animation, but now I can't move my stykman, even when I make a new frame! Also when I add my styk to the library and then put it in a frame, I can't move it! I think that's everything, although I might post again.

[DarkFlame]

Can you explain a little more?

Do you see the nodes?
Does it give you an error?
Is this only for one document?
What version of Stykz are you using?

[Zangdotstyk]

I am using stykz 1.0 for windows. I cannot see the nodes on the styk in my animation after I play it. And if I add the styk into the library while it has no nodes, when I add it into the animation it still has no nodes.

[Monk]

I am using stykz 1.0 for windows. I cannot see the nodes on the styk in my animation after I play it. And if I add the styk into the library while it has no nodes, when I add it into the animation it still has no nodes.

After you play your animation, the nodes on your figures do not display. To fix that press tab. If you do that then add the figure to your library that should fix your problems. The nodes not showing is a known bug, stykzman is trying to fix it. ;D

[Zangdotstyk]

I am using stykz 1.0 for windows. I cannot see the nodes on the styk in my animation after I play it. And if I add the styk into the library while it has no nodes, when I add it into the animation it still has no nodes.

After you play your animation, the nodes on your figures do not display. To fix that press tab. If you do that then add the figure to your library that should fix your problems. The nodes not showing is a known bug, stykzman is trying to fix it. ;D

Thank you very much =D

[stykzman]

I am using stykz 1.0 for windows. I cannot see the nodes on the styk in my animation after I play it. And if I add the styk into the library while it has no nodes, when I add it into the animation it still has no nodes.

After you play your animation, the nodes on your figures do not display. To fix that press tab. If you do that then add the figure to your library that should fix your problems. The nodes not showing is a known bug, stykzman is trying to fix it. ;D

Thank you very much =D

Actually, you probably need to tab TWICE - the first time to take you to Preview mode (where no nodes show on purpose), and then the second time to take you back into Edit mode (where the nodes will be reshown). And "yes", I've already fixe this for the next release.